1984 Jeep CJ wrangler SUV in Frankford, ON

Seller note:

NEW PRICE Must Sell NO TRADESIES I have owned this jeep since 2006 and it had [removed phone]kms on it when I bought it. Now has [removed phone]kms. All work has been done in this time. I only drove the jeep in the summer. The jeep originaly had the 4cyl when I bought it and i swapped in the AMC 360. The swap was done right and I used all the correct OEM parts to do it(motor mounts, rad, clutch and so on) This was a project for me and now i am finished and want to start my next one. My reason for selling is I need funds to start my next project. Below are comlpete details of all work done, I am likely forgetting things but this is most of it. I will sell for $4300 OBO with the stock tires or $5800OBO with the super swampers. I am willing to negotiate. I am selling the jeep UNCERTIFIED, but will need minimum to safety. Jeep is also ETEST exempt because of the age.
Hard top and doors, soft top and doors, bikini top
4.5? Rubicon Express Extreme duty Lift, completely greasable with polyurethane bushings,extended steel braided brake lines, extended sway bar quick disconnect
35X15.50 Super Swamper SX Tires / 15X10 Black Steel rims, only 350kms on tires
AMC Model 20 rear, Complete rebuild with master install kit , One piece axle shafts, 4.56 gears, detroit Locker professional install
Dana 30 front, Complete rebuild with master install kit including ujoints, 4.56 gears, New Warn locking Hubs,professional install
Dana 300 Tcase, T5 tranny, polyurethane tranny mount bushings,
AMC 360 engine, edelbroke performer intake, Holley 670 Truck Avenger carb, Headmen headers with side pipes, complete upper and lower engine seal and gasket kit all these parts I replace and only have about 2000kms on them,doesnt smoke or burn oil, runs excellent, no tiking or knocks, the holley truck avenger carb is awsome and runs smooth at any angle its basicaly as good as fuel injection, engine has 90,000 original kms
New parts include gas tank and gas tank skid, sending unit, fuel pump,wheel cylinders, tail lights, radiator and all hoses, flex light fan, steering box and lines steering box brace, belts, plugs and wires and distributer cap, polyurethane engine mounts and new upper and lower steel mounts OEM, battery and cables, starter,clutch disk and pressure plate, all drive shaft ujoints, thermostat, complete new gauge cluster , Tow hooks, Interior is done with truck bed liner,
Many extra parts I would be willing to negotiate into the price (tranny,tcase,extra hard doors, axles, ect)

Features

• Safety
• Tow hooks