CJ 7 YJ JEEP 1985

in Niagara Falls, ON


Seller note:

cj for parts or finish the rebuild i started.
2.5l chevy engine(ironduke runs) with factory chevy 350 adapter, sr4 transmission plus extra 5 speed t5, dana 300 transfer case,
DANA 44 front from 1973 jimmy with flat top knuckles for high steer, matching 12 bolt rear 3.73 ratio.
newer yj body sandblasted all rust, still needs work(but has new 1/4" reinforced body mounts, with energy suspension mounts, w/grade 8 hardware)
Frame is from a 1982 sandblasted 2 part expoxy primed,
Spring over axle with yj springs front and rear, new u bolts, never installed calipers and never installed extended brake lines.
tilt steering, fiberglass fenders, renegade hood, acura seats,
Jeep yj STEEL half doors with soft uppers (Getting Rare which = expensive)
a couple soft tops with frames
a couple sets of roll bar padding
1995 YJ FAMILY Roll bars with all seat belts and padding
York onboard AIR compressor //
AMC and Chevy starters, alts, etc
Rancho never installed front shocks, othe misc jeep shocks,
6 or so different drive shafts different lengths including a dual cardon shaft
32.5 x 12.5 bridgestone mt on chrome rims
etc etc etc
(will update as i remember)
Chrome/stainless hardware 2 or 3 sets, trailer hitch, fold and tumble rear seat,
NOS "Bullet proof" bolt or weld on chev 350 mounts never used
an older NOS rebuilt never installed dodge carb
Needs for sure,
Brake lines, clutch slave, spring perches welded to axles, full width brackets gusseted...body work finished..may need a new fuel pump, High steer arms
Firm 1000 really FIRM.ASAP FAMILY IS FORCING Me to sell may consider trades plus 600 or so cash

Contact Seller:
By clicking here you have given permission for AllCarsInCanada to transmit you information to seller/partner and for AllCarsInCanada and/or seller/partner to contact you.

Check these out: